On Thu, 8 Jun 2006 09:05:17 -0400, "Colbyt"
wrote:


"KC" wrote in message
.. .
I'm trying to find a replacement part to repair some vinyl plantation
shutters. In a wood shutter, the louvers are attached to the tilt
wand with metal staples, but these shutters have a T-shaped nylon pin.
This isn't the round pin that goes into the stile of the shutter.

The small "wings" of the "T" go inside the louver and the long part
attaches to the tilt want. Of course, these flexible little wings
break off and the louver is disconnected from the tilt wand.

I have searched online to no avail. I can't even find a brand new
shutter that uses this fastener method.

Does anyone know what I'm referring to?

I moved out of the rental unit and the landlord is making an issue of
this. I swear I was about to use a glue gun to "create" enough of a
"wing" to keep the louver from turning!

I'd be grateful for any ideas at all.

KC

Google for interior vinyl shutters parts.

Oh, how I have Googled. There is a great site that has shutter repair
parts and kits and tilt wands, but even they don't have this part.

I had this company in my book marks. The were very good about some presale
questions a few years back.

http://www.riverwoodcompany.com/generic0.html

I did see this site and I'm going to contact them.

I have never seen the part you mention. Most likely it was a cheap product
to start with.

How does it attach to the wand? I can picture the T head going into the
slat.

Yes, exactly like that. I think you would push the head into the
slat.

Thanks for your response.

KC

Colbyt