The channel needs to be fully supported in all directions on both legs
AND the back of the channel while going through the bend area. This is
going to involve some circular slots (probably made from several rings
of suitable dimensions) This is a 3/8" on a 1/2" radius, fairly
difficult so tooling is a must.

Nick Müller wrote:
wrote:


Can anyone point me to a metal shop that could assist me with the
bending of brass channel? I have been beating my head against a wall
trying to bend small (3/8"x3/16") brass channel in a 1/2" radius (the
hard way). I need some professional help at this point.


Haven't done square section tubes jet. But I bet I can do it. The only
two problems a
I'd need to make jigs for that section
I'm from Munich, Germany

Nick