Can anyone help?. Went to do the pre summer check on my garden pond
filter and found that the water level in the container had gone above
the UV lamp and rest of the electrics. Everything bar the housing for
the strip lamp, a bit of wire and the terminals for the lamp ends
required replacing. Bought a new 17" 25w UV strip lamp, after a lot of

trouble eventually got a ballast correct for the lamp. Replaced the
starter housing and starter. Wired it up as I thought I had dismantled
the old one and you guessed it, it wont work.

I will now try to explain my wiring in the hope someone can spot my
mistake. I have a 240V supply with a 5amp fuse(new). I connected the
earth wire to the metal base plate to which I have also attached the
ballast and starter holder. The live is attached to left side of
ballast. There are two wires on each of the end terminals of the strip
light. For description purposes I will say wire 1 from the left side
terminal is connected to the left side of the ballast in the connector
just above the incoming live. Wire 2 from the left strip lamp terminal
is connected to the right side of the ballast. Wire 1 from the right
side strip light terminal is connected to the starter, wire 2 from that

side is connected to the incomming neutral.


My thoughts are that I should probably have a wire from the starter
going to both ends of the strip light not just one but I am at the
guessing stage.


I am now desperate as the water is going greener as the sun goes
brighter!


I have tried to obtain advice from another DIY group and got nothing
helpfull so I am hoping this group is up to the task!

thanks Taylerlee