Building a small workbench - Advice needed
Richard wrote:
Hi everyone,
I am planning to build a small workbench for my shop. The shop is only
8' x10', so space is at a minimum. I usually just build small boxes for
magician's props - usually under 2'x2', so I don't need much space.
you might want to consider putting a plate in it to allow you to
convert it into a router table as well (if space is at a premium). The
idea to make it the same height as the table saw (so it can be an
infeed/outfeed table) is a good one. I have a big assembly table/bench
permanently behind my table saw for an outfeed table.
It's a good idea to make the outfeed table about 1/4" less in height
than the table saw, IMO.
|