DIYbanter - View Single Post

( Doug Goncz ) wrote in message ...
The HF two inch three jaw lathe chuck is threaded M12x1 (fits my Unimat One
at
any rate)

Actually the male thread of the MT 2 adapter fits my Unimat chuck. I doubt that
the chuck centering boss designed in to the One is present. I'll look more
closely some day.

East Coast Hobbies, I think it is for the One, accessories, and parts. HF for
the cheaper One.

Yours,

Doug Goncz (at aol dot com)
Replikon Research, Seven Corners, VA

Went to Harborfreight.com and looked for the chuck. Not there. Then I
entered into a "buy" page the part number you quoted, and up it came.
The same chuck is listed in Harborfreight.com with a slightly
different part number (not reflecting the reduced-sale price). For 20
bucks, I bought one, sight unseen, on the speculation that I will like
it. Haven't gotten it yet, but my Unimat chuck is worn too much to be
accurate anymore.

Brownnsharp

1100 original posts at:
http://groups.google.com/groups?as_e...uthors=dgoncz@