"Grant Erwin" wrote in message
...
I have a little Rockwell 3-phase grinder I picked up recently. It had been
wired completely wrong and today I rewired it and it runs smooth as glass.
I have the same problem with it that I have had with every bench grinder,
though. The shaft spins one way, so the wheels rotate down towards the tool
rest. The nut on one end of the shaft is RH and the nut on the other end is
LH. If I put a wrench on both shaft nuts and crank, one will loosen. The
question is, how do I loosen the other one? I can't for the life of me see
why grinder manufacturers don't put a hole you can put a pin in to lock the
shaft for changing wheels. I sure don't want to put Vise Grips on the naked
threads - what is the trick I'm missing?

GWE
Hold it with your hand on the wheel and put an impact wrench on the other
end. (I know that sounds a bit like Altavoz (sp) but it isn't a lathe
chuck)