In article , Gary Coffman says...

There's also a good series of web articles on buying a used lathe
which would also largely apply to buying a used mill. I can't remember
the URL off hand, but I think it is on Dave Fricken's site. Perhaps
someone else can provide a pointer.

Oh right, I should have mentioned this:

http://www.mermac.com/
http://www.mermac.com/freemill.html
http://www.mermac.com/advice.html

While machines like this are large, they can be
moved around without too much trouble. I've
shifted my small hardinge with nothing but a single
pinch bar.

Jim

==================================================
please reply to:
JRR(zero) at yktvmv (dot) vnet (dot) ibm (dot) com
==================================================