"Leonard Caillouet" wrote in message
...

wrote in message
oups.com...
I am new to this forum and I want to thank anyone in advance who can
help me with my problem.
My friend's stereo amplifier has not worked for a while and I just
surprised her by replacing her amp ( Onkyo ) with a Yamaha A 700. After
connecting everything the stereo seemed to work fine but then the sound
suddenly cut off ( with an audible click) the came back on a few
seconds latter. This would happen everytime I turned up the volume or
changed the balance or switched from stereo to mono. Apparently this is
what happened with her old amp!! The amp seems to cut off in response
to some increased load. She live in an old row home that has been
partially rewired. The outlet is fused to a 20 amp fuse, and the fuse
does not blow.The speaker wire runs through the walls and connected to
terminals on a wall plate. A TV pluged into the same outlet works fine.
(not running TV at the same time). there is no hum or distortion and
the amp does not feel hot. At low vol it plays without cutting out.
What could be the problem ?

Look for old glue that has dried out and absorbed moisture from the air
and
become corrosive, particularly around the PS caps.

Leonard


In both units?