Sorry if I've misinterpreted what the individual was looking for, but
I think what mich do the trick is a endmill holder.
Morse taper (drilled and tapped for drawbar if desired) to 5/8 bore
with locking grubscrew. (try kbctools.com page 390 of their urrent
catalog)

Hope tis is of some use.
gary


On 12 Apr 2006 11:43:35 -0700, "
wrote:

Hi Bill

The MT 2 price at Busy Bee is $9.99 Can. catalog # B460

Drill rod on special right now at Enco, 5/8"D 36" long, runs $5.59 for
water hardening and $6.99 for oil hardening rod, 5/8" carbon steel
$9.85 for 6 feet long this all $ US

They have a lot more sizes and also air hardening steel which is more
expensive, go to page 634 for more info

So depending on what you chose, the cost would be roughly $10.-- +
$3.-- add shipping cost and your cost a piece probably runs less than
$20.--

Have fun and take care
Leo Van Der Loo