T i m wrote:
Hi all,

Is there a gadget out there that would de-burr / put a 45 deg chamfer
on the end of a range of small diameter rods (say 2-10mm dia)?

Like a hand countersink tool would do for a range of small holes, this
*thing* would for rods?

Like a pencil sharpener but at a greater angle and less aggressive?

All the best ..

T i m
A lathe...

:-)

Also, put rod in drill chuck and use static grinding disk,

Also use bench grinder and carefully rotate rod ..

On balance, unless hyper accuracy is required, I'd do the latter.

Bench grinders are pretty cheap in the sheds.