Scale
On 27 Mar 2006 22:32:49 GMT, Dave Hinz wrote:
On Mon, 27 Mar 2006 22:26:59 GMT, Gunner wrote:
On Mon, 27 Mar 2006 19:55:02 GMT, "fred bruce"
wrote:
Is there an easy way to remove scale from hot rolled steel?
Well..if you have a shaper..you can do what I did yesterday...
And, would you consider your method to be successful? Because, from
here, it seems not to be so much.
actually...once I made a new part, to replace the one I broke out of
stupidity and a brain fart..the descaling went right along just hunky
dory. I planed the hot rolled scale off the pieces, flattening them
and squaring them up. I only now have to cut the 45" angle on the ends
of the fingers.
Want a picture of the new crank assembly I made? I took one for my
records. How often can you say you manufactured something out of
hydroflorinated silly putty?
Gunner, who will be pulling his transmission tomorrow to install a new
throwout bearing and slave cylinder..****ing Ford engineers.....
"A prudent man foresees the difficulties ahead and prepares for them;
the simpleton goes blindly on and suffers the consequences."
- Proverbs 22:3
|