Jerome Ranch wrote:

I've got an INCRA fence on my Delta miter box..used it for many years,
zero it on the measuring side of the blade, adjust the rule, set it
for the length of cut, and the length is spot on..but today I'm using
it, same blade, same saw, same everything..it seems cutting short the
kerf of the blade..
can't figure it out since I zero it on the INCRA stop on the measuring
side of the blade, and kerf has nothing to do with the measuring

Any ideas?

Jerry

Two possibilities I can think of an one's a stretch.

One, if your saw has a brake, stops sooner than if you
just let it wind down after power is off, and you didn't
tighten the arbor nut really well when you put the
blade on (years ago?) the nut could be loose and the
blade can wobble just a tad. If you notice the blade
stays spinning well after the power is off that's
a definite possibility - DAMHIKT)

You may have somehow gone off zero degrees and
you're not cutting square ends Have you been cutting
any angles just before things went to hell?

charlie b

charlie b