Can't answer your orifice question in any serious way (lots of off-color humor
comes to mind) but I commend you on your find. A hot steamer will indeed be
useful around your place. I have used hot water under pressure to take off grime
from surprising places. You can also use it to make money removing graffiti
should you choose to, don't know how much tagging goes on in Taft ..

GWE

Gunner wrote:
One of the things I brought home this weekend..was a Mod 530 Hotsy
pressure washer. It had not been run in at least 5 yrs..so they
declared it surplus and loaded it into my trailer with a fork lift.

I had to replace the fuel lines (diesel/fuel oil burner) and putz with
the pressure switches, grease the pump etc etc etc. One wheel was a
cripple, so used the pair I got at the last show in Visalia (perfect
size..$5 for the pair)

Works pretty good. However...I think its running too rich. Now this
may be due to a worn orfice, or the fuel/air mixture is not right. Air
mixture apparently is changed by opening/closing a vented band that
goes around the air intake side of the motor/blower housing. If I open
it too much..I get white smoke and not much heat. If I close it too
much..I get a faint black smoke and not a lot of heat.

There is no online manual on the Hotsy website. Anyone know of the
proper way to set fuel air mixture on a #2 fuel oil blower/igniter
gizmo? Or what I should be looking for as far as the exhaust output
is concerned? Do I need to buy a new nozzle? (I dont think Ive got a
drill bit that small anymore) I think...think there is too much fuel
going out the nozzle as the water tubes in the boiler are now pretty
blackened with soot (after filling the tank with a 5 gallon can here
marked Diesel..but had way way too much oil in it...had to dump it and
go buy some fresh..which did cause it to burn ..the first stuff
wouldnt even catch fire..and covered the tubes with oil..which smoked
a bit as it burned off.

Anyone know what the orfice size should be? I can solder it
shut..then redrill maybe.

I figure this is about the same sort of burner as a residential oil
burner..so...

Thanks

Gunner, now able to clean nasty oily machine tools squeeky clean



"A prudent man foresees the difficulties ahead and prepares for them;
the simpleton goes blindly on and suffers the consequences."
- Proverbs 22:3