Yes this is what I have been doing so far. My present uses have not
required precision. If I need to truly control then I would use a drill
press.

I normally use the countersink bit in a brace and bit. I drill a little,
test the hole against the screw head until I get the whole head to fit in
the hole.

Dave Paine

"Juergen Hannappel" wrote in message
...
Jerome Ranch writes:

Dave
How would you control depth of cut with that style?

With care or preferably the drill presses depth stop.

--
Dr. Juergen Hannappel http://lisa2.physik.uni-bonn.de/~hannappe
Phone: +49 228 73 2447 FAX ... 7869
Physikalisches Institut der Uni Bonn Nussallee 12, D-53115 Bonn, Germany
CERN: Phone: +412276 76461 Fax: ..77930 Bat. 892-R-A13 CH-1211 Geneve 23