According to Norm Dresner :
"Norm Dresner" wrote in message
[ ... ]
| I'm scanning it right now and I'll drop it in as a 3-page .PDF file for
the
| whole manual.
[ ... ]
Done. The manual is there under the name AMT 4030 Drill Press.
O.K. I see where some of the confusion came from. The manual
calls the Jacobs taper on the end of the spindle a Morse taper -- which
is totally incorrect.
Also -- it is a smaller drill press than I was considering, so a
Morse taper in the spindle is quite unlikely. There just is not room
for one of reasonable size. My floor-standing one only has a MT-2, and
I would prefer a MT-3 in that one. Yours *might* accommodate a MT-1,
but that would be too small to be worth the trouble.
Good Luck,
DoN.
--
Email: | Voice (all times): (703) 938-4564
(too) near Washington D.C. |
http://www.d-and-d.com/dnichols/DoN.html
--- Black Holes are where God is dividing by zero ---