In article .com,
david wrote:
have an existing motion sensor light controlled by a switch. Today,
i installed a second motion sensor light in parallel with the first so
that both are controlled by the single switch.

The switch is supposed to be in the "ON" position and the idea was that

either or both motion sensors would illuminate once motion is detected.

However i cannot get the new motion sensor light to come on. I do
have current to the motion sensor as detected by my tester.


I cannot even get it come on even when i bypass the sensor.

New light or its motion detector is defective. Or wired incorrectly.

--
Rich Greenberg Marietta, GA, USA richgr atsign panix.com + 1 770 321 6507
Eastern time. N6LRT I speak for myself & my dogs only. VM'er since CP-67
Canines:Val, Red & Shasta (RIP),Red, husky Owner:Chinook-L
Atlanta Siberian Husky Rescue. www.panix.com/~richgr/ Asst Owner:Sibernet-L