On Tue, 28 Feb 2006 08:20:33 -0500, "George" George@least wrote:


"Peter Hyde" wrote in message
...
In article ,
(Arch) wrote:

IMHO, most woodturning lathe centers are
set too low (or most woodturner's backs are set too high) for efficiency
and comfort.

Over on WOW there was a general consensus that nipple height was right.

Assuming that was for the males only?

good point... So if you see any old ladies on their knees at the lathe... *rofl*

Mac

https://home.comcast.net/~mac.davis
https://home.comcast.net/~mac.davis/wood_stuff.htm