Thread
:
Dealing with Flooded Tools.
View Single Post
#
2
Nick Hull
Posts: n/a
Dealing with Flooded Tools.
In article ,
(Dave Mundt) wrote:
serious damage to the gears, etc, but while the ballbearing on the
motor shaft "seemed" ok, I could tell it was gritty when I tried
turning it. Nothing to do but replace it.
Did you try flushing out the old grease & repacking? The grit was
likely from the flood and the bearing was probably fine if unrusted.
--
Committees of Correspondence web page;
free men own guns - slaves don't
www.geocities.com/CapitolHill/5357/
Reply With Quote