"foggytown" wrote in message
oups.com...
I'm going to do some experimentation. I can't think of any reason why,
with the proper setup, I can't do reasonable finger/box joints on my
router table. Is there? Do them the same way they're don on a TS
except using a straight bit.

FoggyTown


Yes it can be done and I have done it. IIRC An older issue of WoodSmith
shows how to do this. They built a sled that hung over the front and back
edge to guide it on a straight path and had a fence with a key inserted to
position the work. There are numerous plans for jigs out there to do this.