If I recall correctly, the outfeed is cast into the jointer body, ie: it is
an integral part of the jointer.
It is possible to adjust the Infeed side though. There are four screws, one
on each corner. You access them from the bottom. So, you need to turn the
jointer on its side, and if I recall correctly, you must remove the drive
belt to get at those screws.

"SBO" wrote in message
...
I have this Craftsman jointer:

http://www6.sears.ca/webapp/wcs/stor...ctId=158484847

I realised that the infeet and outfeet tables are not parallel. I read the
instruction but it don't talk about it. Is it possible to adjust ?


Thank you !

S.B.