SBO wrote:
I realised that the infeet and outfeet tables are not parallel.

Get ready to get your hands dirty. You may be able to adjust parallel
with machinists shims. Machinists use them to adjust and set up milling
tables and lathe turrets, etc. Those little bench-top tools are usually
not very adjustment friendly. Open it up and see if there is an obvious
adjustment, bolts, wedges,, if not see if shims or washer type shims
will work. Be careful not to raise the out-feed table too far above the
cutters. I don't know how much adjustment you have.

Tom in KY, USA