Thread
:
Lathe way rebuilding
View Single Post
#
6
ATP
Posts: n/a
Lathe way rebuilding
Tony wrote:
No, it's more like a stub morse #5. Even that is off slightly, but
it's pretty close.
Is it South Bend's own taper?
Spammers Beware : Your entering the No-Spam zone
**** Protected by Mailwasher ****
www.mailwasher.net
Caution:Bouncing Spam: Eye protection required!
"ATP" wrote in message
.net...
Fdmorrison wrote:
"SRF"
Just got a South Bend 10" Heavy and the ways are just slightly worn
near the chuck (you can just barely feel a ridge with your finger
nail).
....
That's typical for an older lathe. Some drop of the ways there is
not going to make a lot of practical difference to what the lathe
will make for you. As part of setting up, try turning the ends of a
piece of stock (say twelve inches long) between centers (using a
faceplate and lathe dog rather than a chuck).
Does the Heavy 10 headstock spindle take a #5 Morse taper?
Reply With Quote