Gib screws and nuts
In article , GMasterman says...
Got an old Sheldon 11X40 and need to replace the gib screws and lock nuts. The
1/4X28 screws are no real big problem but I have never seen any of the small
cross-section nuts like the factory used. No room for standard nuts. Any ideas?
1) take smaller nuts (say, 10-32) and drill and tap up to 1/4-28.
2) If it is thickness you are worried about, face down standard
nuts by using a threaded mandrel to hold them.
3) Fabricate your own! That's what lathes are all about.
Jim
==================================================
please reply to:
JRR(zero) at yktvmv (dot) vnet (dot) ibm (dot) com
==================================================
|