WillR wrote:
Dave Hinz wrote:

Is there a good way to take a kink out of a 1" wide bandsaw (resaw)
blade? Not sure how it got there, and the usual suspects aren't owning
up to anything, but it's got the expected results in the cut quality.
How do I fix this, or is it trash?

Dave Hinz



Cut out the kink and re-weld it? A small loss of length shouldn't matter
on most bandsaws...

Otherwise...

If it won't unkink by rolling it over a smaller radius roller than the
wheel, start bit then decrease according to what you have, make bowsaws.
Larry can tell you how.
Joe