On Sun, 11 Dec 2005 08:03:44 GMT, Gunner Asch
wrote:

I dealt with Howard - we had a nice chat about high performance cars -
his place is, he says, about 300 machines short of normal", but it
sure is a nice clean place compared to many I have visited.


Did you deal with Howard or Dana? I do a fair amount of business in
there for my clients..didnt know they were on Ebay yet. Got my Airco
Squarewave 300 as commission for selling some machines for them.
The Harrison tool and cutter grinder was outback collecting rust..next
time you go in...wander out to the back 40 and check under the
rust..some interesting stuff back there....

Personally..Id use a magnet.. Or simply drill and tap for a short
setscrew. Shrug.

Ive got a Lassey with the built in "vise" but have used that one..and
as another poster said..the stock pin locations really dont cut it.
1/4" pins on 1" centers is good for small stuff. Unless you have a
small machinists vise....

Gunner

"Pax Americana is a philosophy. Hardly an empire.
Making sure other people play nice and dont kill each other (and us)
off in job lots is hardly empire building, particularly when you give
them self determination under "play nice" rules.

Think of it as having your older brother knock the **** out of you
for torturing the cat." Gunner
Bill

www.wbnoble.com

to contact me, do not reply to this message,
instead correct this address and use it

will iam_ b_ No ble at msn daught com