Greg,

I can't get the links to come up with anything. What am I doing wrong?

TomNie

"Greg G." wrote in message
...

Well, I finally got around to upgrading and replacing various tablesaw
sleds and jigs to fit the new saw. And in addition to the mandatory
crosscut box, I designed an add-on for cutting small wedge segments
for turned vessels.

I looked at various designs that others pointed out, and decided to
build this instead. BFG I will build one dedicated add-on jig for
each of the common angles (12 sides, 16 sides, 18 sides).

This jig has not even been fine tuned, but this will be accomplished
by gently sanding the left or right locating boss slightly - then it
is forever aligned perfectly - as long as the main sled survives.
I considered putting an allen head adjustment screw in one boss for
tweaking, but it really wasn't necessary. KISS is my motto. You can
cut through the middle of an 8 foot stick with this design.

The stop block is adjustable for differing lengths of segments.
Yes, it requires a screwdriver - big deal. I guess I could put a
couple of knobs on it when it starts to bother me.

The jig is retained securely to the sled by 1/4" x 20 screws and
T-nuts which are marked by the blue arrows. One keeps the jig
securely sandwiched to the sled, adjacent to the hold-down clamp, and
the other insures that the jig is held against the rear fence so that
the proper angle is maintained. You obviously don't want to torque
down on this one too hard or you'll bow the 'fence' g

The 3/4 inch 'fence' face was jointed perfectly flat and true.
It is HDF core cabinet plywood. I will lacquer the whole mess later.

The crosscut sled is shown here, with the mitre accessory alongside:
(This one is for 12 sided vessels, or 15 degrees.)
You can also _just_ make out the homemade table insert.

http://www.thevideodoc.com/Images/SegmentJig01.jpg

This is the assembled jig, ready for work:

http://www.thevideodoc.com/Images/SegmentJig02.jpg

And this is the result of the first test cuts:
(Barreling of the camera lens doesn't do this shot justice.)

http://www.thevideodoc.com/Images/SegmentJig03.jpg

Pretty good, no? First shot, no sanding, straight off the saw.
Man, I love that geared dial protractor. And the best part?
No high dollar blue or red extruded aluminum. g

FWIW,

Greg G.

Greg G.