"Keith" wrote in message
...
I'm in the final steps of sanding a project and have noticed some sanding
swirl
marks. I have been very careful to step up the sanding grades from
120-150-180-220. I have even tried handing sanding this test board. I
still
can't seem to remove all the swirl marks. I haven't used walnut before so
I may
have to drop back and try the sanding process again from 120 grit or
lower. Is
walnut that hard that it may require a lower sanding grit to start from. I
have
paper from 80 for my sander. I'm using a festool 150/3 sander.
I was going to use Pore-O-Pac paste wood grain filler first then use a
tung
oil.
Is there another way I should consider for a natural grain glass smooth
finish.
I haven't used a wood grain filler before so this is all new.
Thanks again.


Actually Black and or American Walnut is pretty soft compared to Oak. I
never go past 180 on Walnut or any other wood and usually start with 150.