I've got a 5914 with taper. There's a clamp on the right end of the taper
attachment. It grabs hold of the rear way Tighten the two screws and the
taper is engaged. The cross slide follows the bar on top of the taper
attachment. To adust the taper loosen the screws at each end of the taper
bar and adjust the amount of the taper by turning the micrometer like
thimble on the right rear of the taper attachment. The scales at the end of
the taper bar are calibrated in inches per foot on one end and degrees on
the other. I don't remember which is which without the manual. The maual is
available from Clausing fo $25. Call them with the serial # of your lathe
and they'll custom build a manual. Ask for the parts price list also. When
you look at the parts prices have some nitroglycerin pills handy. Good luck,
Tom
wrote in message
ups.com...
I have a clausing model 5914 with a taper attachment. I am not clear
how to set it up. The first thing I need to know is how do I hold the
tapper bar in place as the tool post moves along the way. Any
additional help you can provide will be greatly appreciated. Thank
you.