"ChrisGW" wrote in message
...
wrote:
Hi. I am wanting to get into welding, and I have a question for those
who may know. What kind of welder would be used to make a vent like
this http://oldworlddistributors.com/pix_...ryer_vent.html.
Thanks

That is soldered not welded.

ChrisGW


It's also been scotch brited as you can see in the side view at the bottom
where the pivot comes through the scotch brite couldn't get to the area
above and below the pivot revealing that work was done to clean this up
after soldering. Were I work they have a brite dip that they use to remove
the flux residue and any oxidation that took place during the heating then
the brite dip is rinsed off with water.

Rich