wrote:
I would appreciate any advice on adjusting the thickness table. The gear underneath the worm screw where the handle attaches became loose, and the table would not raise or lower. I was able to press the gear back in place, but found that stock passed through the planer was out of square. Naturally, I disocvered that Inca went out of business three years ago. Thanks in advance for any assistace. Michael Goldin There's an Inca-specific group on groups.yahoo.com - someone there might be able to help if you don't get any good suggestions here. |
All times are GMT +1. The time now is 10:30 PM. |
Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2014 DIYbanter