Hot on the heals of the headboard job I began the new entertainment
center job.

This is the final drawing.

https://www.flickr.com/photos/lcb11211/15140867902/

This is where I am at. I have just over 450 linear inches of dado's and
grooves on X,Y, and Z axis that all have to line up perfectly so that
everything locks together. Bottom panel into end panels dado's, mid
panels into the bottom panel dado's and all of those panels into the
front and back face frames groves and dado's. And because the back face
frames and front face frames are assembled differently, their respective
rails top and bottom are 1" different in length. This is where being
anal comes in handy when measuring. This was the first test fit after
gluing up the face frames. I have built 62 face frames in the last 32
months this way.

The back face frames feature lap joints to form rabbets for the back
panels, reinforced with 5mm Dominoes. The front face frames are butt
joints reinforced with 5mm Dominoes also.

Next step, pop it all apart and add glue, 450 inches of glue. ;~)


The back side,

https://www.flickr.com/photos/lcb112...n/photostream/

The front side,

https://www.flickr.com/photos/lcb112...n/photostream/

And an inner detail

https://www.flickr.com/photos/lcb112...n/photostream/

On Thursday, September 4, 2014 4:16:25 PM UTC-5, Leon wrote:
Hot on the heals of the headboard job I began the new entertainment center job.

Even the plans look sharp. The installed headboard is excellent.... I hadn't seen that pic, previously.

Sonny

On 9/4/2014 8:19 PM, Sonny wrote:
On Thursday, September 4, 2014 4:16:25 PM UTC-5, Leon wrote:
Hot on the heals of the headboard job I began the new entertainment center job.

Even the plans look sharp. The installed headboard is excellent.... I hadn't seen that pic, previously.

Sonny



Thank you!