I am trying to make a saw. I need to find a mandrel (Shaft, pillow blocks,
pulley) that has a 1" threaded shaft.
Does anyone have a source for something like this?

Thanks

Dan Burkhardt
Signs of Wood, Co.
http://www.signmakershop.com

Dan Burkhardt wrote:

I am trying to make a saw. I need to find a mandrel (Shaft, pillow blocks,
pulley) that has a 1" threaded shaft.
Does anyone have a source for something like this?

Thanks

Dan Burkhardt
Signs of Wood, Co.
http://www.signmakershop.com

Grizzly used to carry what you're looking for. I think Enco may;
and I'd be astonished if McMaster-Carr doesn't, too.

http://www.grizzly.com
http://www.use-enco.com
http://www.mcmaster.com

You might also try http://www.grainger.com

--
Morris Dovey
DeSoto, Iowa USA

On Thu, 27 May 2004 18:36:06 -0700, "Dan Burkhardt"
stated wide-eyed, with arms akimbo:

I am trying to make a saw. I need to find a mandrel (Shaft, pillow blocks,
pulley) that has a 1" threaded shaft.
Does anyone have a source for something like this?

Try www.mcmaster.com or www.mscdirect.com , Dan.


-
Yea, though I walk through the valley of Minwax, I shall stain no Cherry.
http://diversify.com

I am trying to make a saw. I need to find a mandrel (Shaft, pillow blocks,
pulley) that has a 1" threaded shaft.
Does anyone have a source for something like this?

Like this?
http://www.leevalley.com/wood/page.a...,43 072,45939
There was also a fine cast iron bodied one at
http://www.traditionalwoodworker.com/ as a close-out or maybe it was at
http://shop.woodcraft.com/Woodcraft/...asp?URLCheck=1
but I guess not because this is all I found the
http://shop.woodcraft.com/Woodcraft/...9D885350597A3C
but then I found it here from a search:
http://www3.woodcraft.com/PowerToolA...rking/4649.htm
Then the same became cheaper on this page, I think it is a closeout:
http://shop.woodcraft.com/Woodcraft/...8853505 97A3C
Then I found it IS a closeout on this page:
http://shop.woodcraft.com/Woodcraft/...9D885350597A3C
and Grizzly has another kind with a 5/8" shaft he
http://www.grizzly.com/products/item...&StartR ow=11
And http://woodworker.com/ has them here too:
http://woodworker.com/cgi-bin/FULLPR...ARTNUM=818-753

Since I have the same interest I did the searching and it's all
I could find, but I think you should get one of these and
search high and low for that threaded 1" adapter at the other
sites posted for you. It looks like these mandrels need to be
mounted up higher as shown in the Lee Valley page.

Alex