As soon as I discovered that they sell aftermarket shelix cutterheads
for my Delta, and once I found a website where a guy showed the steps
he took to put his in (convincing me that I wouldn't destroy my own
jointer if *I* tried it)... well.... I just couldn't hold my wallet in
my pocket anymore. I swear... it just sprang right out of my pocket
when my guard was down.

Anyway, here's the page detailing the purchase and installation. I had
it all installed in less than 2 hours. I'll post more about it as I
get some quality time in with the thing.

http://joe.emenaker.com/Shelix/

- Joe

Joe Emenaker wrote:

Anyway, here's the page detailing the purchase and installation. I had
it all installed in less than 2 hours. I'll post more about it as I
get some quality time in with the thing.

http://joe.emenaker.com/Shelix/

Cool! I've got a similar jointer, that page will come in handy if I
ever decide to take a similar plunge. Thanks!

--

If you want to reply via email, change the obvious words to numbers and
remove ".invalid".

the only real hassle is getting the new bearings on. I had to grind a
little bit off the front and back of my table on my shopfox. but it
was real easy and I have about 2 years on it now.