Excuse me if this is a repost of my request. I tried to post it previously
and it did not show up in my sent folder, so I posted it again.

I have a Grizzly G0444Z TS. The back of my blade when I rip a board is
almost a quarter of an inch closer to the fence than the front of my blade
and causes gunk to build up on the right side of the saw blade, and causes
the board to bind up and I have to force it through. .I used ovenoff to
clean the blade. My sawblade is not bent. According to my saw manual it says
to loosen the trunnion bolts and move the assembly to the right or left and
retighten the bolts. I did this I cannot get the blade dead-on. The assembly
will not move any farther. It is off by a 1/16th of an inch. Is this an
acceptable tolerance or do any of you have any suggestions as to how I can
get it perfect? Thank you all for your suggestions.