Jessem Router Plate and Table
 

I purchased the Jessem Rout R plate and Jessem Mast R Top. The plate
fits the table insert, however, the plate does not lay level with the
table. How does one adjust the plate so that it sits level with the
table top. The Jessem Master Plate has adjustments but none that I can
see or figure out on the "plain" Router Plate. Any help or suggestions
would be appreciated. I have tried contacting Jessem but haven't gotten
a response yet.

Jessem Router Plate and Table
 

Gary,
Thanks for your reply, however, I don't have the Mast R plate, I have
the Rout R plate.
Are the screws on the underside of the Mast R plate?
wrote:
On 9 Oct 2006 13:25:32 -0700, "cayvman"
wrote:

I purchased the Jessem Rout R plate and Jessem Mast R Top. The plate
fits the table insert, however, the plate does not lay level with the
table. How does one adjust the plate so that it sits level with the
table top. The Jessem Master Plate has adjustments but none that I can
see or figure out on the "plain" Router Plate. Any help or suggestions
would be appreciated. I have tried contacting Jessem but haven't gotten
a response yet.


The Mast R plate I have has a black piece in each corner with a screw
for adjustment.

Gary

Jessem Router Plate and Table
 

On 9 Oct 2006 13:25:32 -0700, "cayvman"
wrote:

I purchased the Jessem Rout R plate and Jessem Mast R Top. The plate
fits the table insert, however, the plate does not lay level with the
table. How does one adjust the plate so that it sits level with the
table top. The Jessem Master Plate has adjustments but none that I can
see or figure out on the "plain" Router Plate. Any help or suggestions
would be appreciated. I have tried contacting Jessem but haven't gotten
a response yet.

Like gkemper said: If the plate itself does not have leveling screws,
the solution is to put screws at each corner of the table where the
insert fits. This is how the Rockler insert is leveled. In fact,
Rockler has some nice screws for this purpose. Blunt ended, not
pointy sharp like typical wood screws.

Jessem Router Plate and Table
 

Thanks all. Went home last night and looked in the original packing and
lo and behold there was 8 set screws and an allen wrench. Funny thing,
though, that in all "manual" it says nothing about the leveling screws.
The only reference to them is on the label of the packing box.
George Max wrote:
On 9 Oct 2006 13:25:32 -0700, "cayvman"
wrote:

I purchased the Jessem Rout R plate and Jessem Mast R Top. The plate
fits the table insert, however, the plate does not lay level with the
table. How does one adjust the plate so that it sits level with the
table top. The Jessem Master Plate has adjustments but none that I can
see or figure out on the "plain" Router Plate. Any help or suggestions
would be appreciated. I have tried contacting Jessem but haven't gotten
a response yet.

Like gkemper said: If the plate itself does not have leveling screws,
the solution is to put screws at each corner of the table where the
insert fits. This is how the Rockler insert is leveled. In fact,
Rockler has some nice screws for this purpose. Blunt ended, not
pointy sharp like typical wood screws.