[[email protected]]

I have a particle board shelf where the vinyl lamination has partially
come off on the front of it (1/2" height strip that runs for the 24"
length of the shelf) I'm trying to fix it, but I am unsure of what
type of glue was originally used.

The existing glue dried white, if that is any help

Does anyone have any suggestions on how to spot repair the vinyl
lamination that is lifting? The lamination came off the glue because
we were pulling a cardboard box from the shelf and it was catching the
edge of the vinyl and eventually peeled part off about a 12" section of
it. There is no glue on the vinyl, it is all still on the particle
board.

[Dave Bugg]

wrote:

Does anyone have any suggestions on how to spot repair the vinyl
lamination that is lifting?

A bit of a silicone caulk adhesive would work just fine.
--
Dave
www.davebbq.com

[CC]

wrote in message
ups.com...
I have a particle board shelf where the vinyl lamination has partially
come off on the front of it (1/2" height strip that runs for the 24"
length of the shelf) I'm trying to fix it, but I am unsure of what
type of glue was originally used.

The existing glue dried white, if that is any help

Does anyone have any suggestions on how to spot repair the vinyl
lamination that is lifting? The lamination came off the glue because
we were pulling a cardboard box from the shelf and it was catching the
edge of the vinyl and eventually peeled part off about a 12" section of
it. There is no glue on the vinyl, it is all still on the particle
board.


3MT Hi-Strength 90 Spray Adhesive

http://www.ellsworth.com/display/pro...3&Tab=Products

CC

[Tim W]

wrote in message
ups.com...
I have a particle board shelf where the vinyl lamination has partially
come off on the front of it (1/2" height strip that runs for the 24"
length of the shelf) I'm trying to fix it, but I am unsure of what
type of glue was originally used.

The existing glue dried white, if that is any help

Does anyone have any suggestions on how to spot repair the vinyl
lamination that is lifting? The lamination came off the glue because
we were pulling a cardboard box from the shelf and it was catching the
edge of the vinyl and eventually peeled part off about a 12" section of
it. There is no glue on the vinyl, it is all still on the particle
board.


IIUC you have vinyl edge-banding coming off a melamine board. It is normally
glued on with hot melt glue so sticking it back is as easy as pie. A clothes
iron, set not too hot will warm the glue enough to press it back on. a piece
of paper will keep the glue off the iron. Trim the edge with a sharp knife
or very fine abrasive paper if you need to.

Tim w