I am in need of some help wiring up the original magswitch on a Grizzly

G-1012 band saw.

The story is that when checking out this new-condition, second-hand saw
it kept tripping the circuit. For some reason, at some point, I
figured the
problem was in the switch. After trying the switch from the duct
collector,
I discovered that the 240 rewire on the motor was done wrong (hence
the
new condition). So, I eventually put the switch back on the dust
collector
and need to get the original saw magswitch back on so I can finally get
some
resawing done.

Oh, yes, the big mistake was not writing down the simple wiring
config
and not getting the thing back on soon enough to remember.

I've talked to Gizz tech support and googled around but can not get
clear
instruction on the easy wiring of this complex looking switch.

Could someone with that saw or another Grizz product with that switch
please open their switch and give me the ABCs of getting rewired ?

This is the switch: http://tinyurl.com/gwlwl
This is the saw:
http://images.grizzly.com/grizzlycom...ls/G1012_m.pdf
This is not my wife nor my tool belt: http://tinyurl.com/khz4v

Thanks, Bart

On 12 May 2006 12:40:55 -0700, wrote:

This is not my wife nor my tool belt: http://tinyurl.com/khz4v

But, did you apply the fine oil finish?

--
Art