Hi All,

I'm looking for plans to build benches and flower boxes for a deck. Here's
the catch, the deck is made from TimberTech which is a composite wood and
only comes in 5/4 x 6 or 3/4 x 10 or 12. I would like to make the benches
and flower boxes out of the same composite. The composite cuts and routers
well but if I do glue ups and have to plane or sand it, I'm going to lose
the wood grain effect.

So, I have to work with the boards as they are or trim them smaller. Any
ideas?

Thanks,
Joe

"Joe Ferraro" wrote in message

So, I have to work with the boards as they are or trim them smaller. Any
ideas?

Thanks,
Joe

I'd work with the boards as they are or trim them smaller.

Edwin Pawlowski wrote:
"Joe Ferraro" wrote in message

So, I have to work with the boards as they are or trim them smaller. Any
ideas?

Thanks,
Joe


I'd work with the boards as they are or trim them smaller.




I'm with Ed.

On just about any project, I usually work with the boards as they are or
trim them smaller. Sometimes, I have to trim them more than once.