| Home |
| Search |
| Today's Posts |
 |
|
Menu
| Woodworking (rec.woodworking) Discussion forum covering all aspects of working with wood. All levels of expertise are encouraged to particiapte. |
| Reply |
|
|
LinkBack | Thread Tools | Display Modes |
|
|
| Woodworking (rec.woodworking) Discussion forum covering all aspects of working with wood. All levels of expertise are encouraged to particiapte. |
| Reply |
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
|
|||
|
|||
Incra 1000se miter gauge
Anyone know if it can be used in a right-side miter slot?
Thanks! PK |
|
#2
|
|||
|
|||
|
Yes takes less than 5 min. to change.
Keith "PK" wrote in message ... Anyone know if it can be used in a right-side miter slot? Thanks! PK |
|
#3
|
|||
|
|||
|
That's good. I knew the 1000 could be used from either side, but I
didn't know about the extendable fence on the 1000se. Thanks! PK On Tue, 13 Sep 2005 17:30:42 -0700, "Keith" wrote: Yes takes less than 5 min. to change. Keith "PK" wrote in message .. . Anyone know if it can be used in a right-side miter slot? Thanks! PK |
|
#4
|
|||
|
|||
|
PK wrote in
: Anyone know if it can be used in a right-side miter slot? Thanks! PK Like Keith said - it's a fast switch. My TS is setup to really favor the right side mitre slot. The instructions walk you through the setup for Left, so just swap the extension fence over to the right and then continue with setup. |
| Reply |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Review of the Osbourn 3 miter gauge | Woodworking | |||
| Sliding Table vs new miter gauge for TS | Woodworking | |||
| Ridgid TS miter slot and Delta miter gauge? | Woodworking | |||
| Incra V27 Miter Gauge - Anyone use it? | Woodworking | |||
Linear Mode
