Piece of ash, round two (0/1)
Set of pics before I screw it up or it comes apart..
Last hollowing was at about 1,300 rpm.. BTW, it's a small piece, final diameter is about 8"..... mac Please remove splinters before emailing |
Piece of ash, round two (0/1) (0/1)
On Wed, 14 Oct 2009 08:50:48 -0700, mac davis
wrote: No pictures??? I'll try again.. Set of pics before I screw it up or it comes apart.. Last hollowing was at about 1,300 rpm.. BTW, it's a small piece, final diameter is about 8"..... mac Please remove splinters before emailing mac Please remove splinters before emailing |
Piece of ash, round two (0/1) (1/1)
4 Attachment(s)
|
Piece of ash, round two (0/1) (1/1)
mac davis wrote:
Still using the old spigot, eh? Turned out good. Doncha hate hollowing out below the rim! -- Gerald Ross Cochran, GA No man is an island, but then no man is a potato salad, either. |
Piece of ash, round two (0/1) (1/1)
On Thu, 15 Oct 2009 11:38:45 -0400, Gerald Ross wrote:
mac davis wrote: Still using the old spigot, eh? Turned out good. Doncha hate hollowing out below the rim! Spigot?? WasAt? Just started playing with simple hollowing, Gerald.. Gotta get lots of use out of the Eliminator if I want to Buy a Hunter hollower.. mac Please remove splinters before emailing |
Piece of ash, round two (0/1) (1/1)
Wow.. Is that the same piece of ash! What a difference.. Would neve have
guessed it would have so much color, mineral deposits and grain variation.. Looks like money to me, Mac.. Just in time for the holiday season.. -Jim "mac davis" wrote in message ... |
Piece of ash, round two (0/1) (1/1)
On Sat, 17 Oct 2009 23:31:40 -0700, "Jim Hall"
wrote: Wow.. Is that the same piece of ash! What a difference.. Would neve have guessed it would have so much color, mineral deposits and grain variation.. Looks like money to me, Mac.. Just in time for the holiday season.. -Jim It's been a real time consumer, that's for sure... Spalting is nice, but there always seem to be punky spots or weird end grain.. I've been sanding, flooding with Danish oil, and sanding.. about 5 times so far.. More sanding than I should need, but it's a pretty deep undercut and I don't have the skill or tools to do it without major tool marks at the transitions.. Hoping that in this market that it will bring about $125 but not holding my breath.. NOBODY has any money down here this year... Big show on Oct. 28th and it might have a chance there.. mac Please remove splinters before emailing |
All times are GMT +1. The time now is 02:55 PM. |
Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2014 DIYbanter