Junniper
"Keith Young" wrote in message ...
Hi I have a quantity of Juniper. Its dryed out and badly cracked on the surface. Tryed turning a vase with it but hated the plywood look. I have seen some marvelous turning with this wood, but the grain that i get from end turning is not very attractive. Any suggestions Keith ================================================== ======================== Mornin" Keith: I do turnings out of Honey Locust and Hackberry. Both of these woods have a pretty straight grain. To add to the visual effect, I cut pieces diagonally across the grain and get some interesting looks. Another way is to slightly set the tailstock off center before truing up your cylinder. This will give you more figuring along the sides. Good Luck, The Other Bruce |
Thanks Bruce
So experiment and turn the end grain at a 45 degree angle .. Thanks Keith "Bruce" wrote in message om... "Keith Young" wrote in message ... Hi I have a quantity of Juniper. Its dryed out and badly cracked on the surface. Tryed turning a vase with it but hated the plywood look. I have seen some marvelous turning with this wood, but the grain that i get from end turning is not very attractive. Any suggestions Keith ================================================== ======================== Mornin" Keith: I do turnings out of Honey Locust and Hackberry. Both of these woods have a pretty straight grain. To add to the visual effect, I cut pieces diagonally across the grain and get some interesting looks. Another way is to slightly set the tailstock off center before truing up your cylinder. This will give you more figuring along the sides. Good Luck, The Other Bruce |
"Keith Young" wrote in message ...
Thanks Bruce So experiment and turn the end grain at a 45 degree angle . Thanks Keith "Bruce" wrote in message om... "Keith Young" wrote in message ... Hi I have a quantity of Juniper. Its dryed out and badly cracked on the surface. Tryed turning a vase with it but hated the plywood look. I have seen some marvelous turning with this wood, but the grain that i get from end turning is not very attractive. Any suggestions Keith ================================================== ======================== Mornin" Keith: I do turnings out of Honey Locust and Hackberry. Both of these woods have a pretty straight grain. To add to the visual effect, I cut pieces diagonally across the grain and get some interesting looks. Another way is to slightly set the tailstock off center before truing up your cylinder. This will give you more figuring along the sides. Good Luck, The Other Bruce ================================================== ============================ Evenin' Keith: The angle doesn't have to be as much as 45 degrees. Sometimes 10 - 25 degrees brings some interesting results. Bruce |
On Wed, 20 Oct 2004 07:05:24 -0230, "Keith Young"
wrote: Hi I have a quantity of Juniper. Its dryed out and badly cracked on the surface. Tryed turning a vase with it but hated the plywood look. I have seen some marvelous turning with this wood, but the grain that i get from end turning is not very attractive. Any suggestions Keith I turned some wet and then nuked it in the microwave. It warped but after a polishing with the beall system it looked great. Kinda almost sorta a alabaster slash ivory slash whatever look... eric |
All times are GMT +1. The time now is 01:55 PM. |
Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2014 DIYbanter