I posted about this a while back, but George still has a weekend available
Sept. 20-21. George has been teaching spindle turning at the technical
college level in Sydney Australia for many years. This will be his third
trip to the US, and he has been well received each time. He will demonstrate
how to design and duplicate spindles such as table legs in less time than it
takes to set up some kind of duplicator. Don't pass it up if you are looking
for a good demonstrator. If you are close enough to come to Nashville Sept.
14 you are welcome to come to his demo here.

contact George at:




If you are interested in coming to Nashville email me.

John Jordan

www.stubbylathe.com

"John Jordan" wrote in message ...
I posted about this a while back, but George still has a weekend available
Sept. 20-21. George has been teaching spindle turning at the technical
college level in Sydney Australia for many years. This will be his third
trip to the US, and he has been well received each time. He will demonstrate
how to design and duplicate spindles such as table legs in less time than it
takes to set up some kind of duplicator. Don't pass it up if you are looking
for a good demonstrator. If you are close enough to come to Nashville Sept.
14 you are welcome to come to his demo here.

contact George at:




If you are interested in coming to Nashville email me.

John Jordan

www.stubbylathe.com

Hi John,
Just wanted to let you know that I still have a few dates open as
well. If you or Ray wanted to put me up I would be glad to demo for
the TAW folks at a discounted rate. Book me early. Starting in
September I start a tour of Europe with Brad.
God Bless,
Al Kyder