craftsman bench top drill press drill holder model 335.25987
i like to know any feed back how how worthwhile it is to buy this
specific product and also in general how this type of drill press is? is it accurate in terms of run out and also the perpendicularity? is it easy to put the drill in and take it out? thanks ~B |
craftsman bench top drill press drill holder model 335.25987
bizHB wrote:
i like to know any feed back how how worthwhile it is to buy this specific product and also in general how this type of drill press is? is it accurate in terms of run out and also the perpendicularity? is it easy to put the drill in and take it out? thanks ~B I've owned it. Many years ago. I gave it to my ex-wifes new boyfriend. That may tell you all you need to know. I hope he used it on something important -and- expensive. Run out is determined by the drill. The rack tracks fairly perpendicular, but where the hole ends up is HIGHLY dependent on how straight you got the drill motor. And how you define 'perpendicular'. The table is not perpendicular to the column in any except the most casual of senses. But, if you are careful how you clamp the drill in, the bit might run parallel to the column. Then again, it might not. In any case, it will not be perpendicular to the table. Fine for punching shallow / smaller holes with the motor running at full speed but not a replacement for a regular drill press with dedicated motor and multi-speed spindle. Even a Chiwanese drill press will outperform this tool. I'd recommend that you give it a pass and save your change for a scaled back 'real' drill press. Bill -- http://nmwoodworks.com/cube --- avast! Antivirus: Outbound message clean. Virus Database (VPS): 000735-2, 04/23/2007 Tested on: 4/24/2007 1:48:07 AM avast! - copyright (c) 1988-2007 ALWIL Software. http://www.avast.com |
craftsman bench top drill press drill holder model 335.25987
Ditto, Ditto, DITTO to what Bill said. You will do much better with
the drill hand held. I saved mine to give to someone I really dislike but haven't found someone I hate that much - yet. |
All times are GMT +1. The time now is 02:14 AM. |
Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2014 DIYbanter