Bought a pre-assembled split load cons. unit from Screwfix
(http://www.screwfix.com/app/sfd/cat/...NYCEKYXCJO2C4C
J0Q?id=82204&ts=15099) a couple of months ago.

Fitted it and connected everything apart from the light circuits as I was
planning to re-wire all of them at a later stage.

Today I finished re-wiring the light circuits, and found out that 4 of the 5
MCBs (the four left-most in the picture) have all failed. They have not been
used since the box was bought, and are clearly faulty - switches either up
(on) or down (off) result in no contact.

Nothing major (never had a problem with Screwfix in these situations, and I
will be very surprise if they don't replace the faulty ones) - just looks a
bit strange....

Any thoughts?

The bus bar is under the tightening terminals at the bottom as opposed
to clamped inside?

Regrda
Legin

The bus bar is under the tightening terminals at the bottom as opposed
to clamped inside?

Regrda
Legin

"legin" wrote in message
ups.com...
The bus bar is under the tightening terminals at the bottom as opposed
to clamped inside?

This seems to be common on Volex boards. They are a swine to add a new
breaker without dropping the bus bar.

Adam