Just bought a combined bath outlet and overflow kit. This was supplied
with numerous washers and instructions written in pidgeon English
which don't seem to match the parts as usual.

I've identified most bits but one of these is a foam washer which
seems to nicely fit as a seating under the fitting for the circular
outlet metal plate (plug hole!) . Does this make sense to anyone if
it does, why foam and not rubber, although there is a rubber washer
for the outside of the bath will this be water tight?

Is it advisable to also silicone sealant and where should I put this .

I know this is a bit vague but you never know, are there any sites
with diagrams out there?

Thanks to anyone with an answer

Graham

"Graham Mead" wrote in message
om...
Just bought a combined bath outlet and overflow kit. This was supplied
with numerous washers and instructions written in pidgeon English
which don't seem to match the parts as usual.

I've identified most bits but one of these is a foam washer which
seems to nicely fit as a seating under the fitting for the circular
outlet metal plate (plug hole!) . Does this make sense to anyone if
it does, why foam and not rubber, although there is a rubber washer
for the outside of the bath will this be water tight?

Is it advisable to also silicone sealant and where should I put this .

I know this is a bit vague but you never know, are there any sites
with diagrams out there?

Thanks to anyone with an answer

Graham


I think you have this slightly wrong Graham. The firm washer sits between the
metal grating and the bath to stop water seeping passed and out down the thread
of the body on the waste/overflow. The spongy washer goes to the bottom of the
bath to take the shape better, and to put tension against the metal grating, and
it holds all the sandwiches of washers and metal things firmly in place.

BigWallop wrote:
"Graham Mead" wrote in message
om...

Just bought a combined bath outlet and overflow kit. This was supplied
with numerous washers and instructions written in pidgeon English
which don't seem to match the parts as usual.

I've identified most bits but one of these is a foam washer which
seems to nicely fit as a seating under the fitting for the circular
outlet metal plate (plug hole!) . Does this make sense to anyone if
it does, why foam and not rubber, although there is a rubber washer
for the outside of the bath will this be water tight?

Is it advisable to also silicone sealant and where should I put this .

I know this is a bit vague but you never know, are there any sites
with diagrams out there?

Thanks to anyone with an answer

Graham



I think you have this slightly wrong Graham. The firm washer sits between the
metal grating and the bath to stop water seeping passed and out down the thread
of the body on the waste/overflow. The spongy washer goes to the bottom of the
bath to take the shape better, and to put tension against the metal grating, and
it holds all the sandwiches of washers and metal things firmly in place.


Lol, who to believe!
The instructions that came with the waste kit for our bath state that
the foam washer should preferably be discarded and silicone sealant used
between the outlet and the upper bath surface, with the firm rubber
washer on the underside of the bath.
I used Fernox LS-X...

Lee
--
Email address is valid, but is unlikely to be read.

Lee wrote:

silicone sealant used
between the outlet and the upper bath surface

This was specifically for an acrylic bath though, steel may be different.
Just found the instructions* and they state the use of silicone sealant
is recommended to "prevent any water getting in between the top acrylic
layer and the fibreglass" - sort of see the point they are making.
Don't know how likely this is to cause damage in practice though.

*Yes I know, must throw out some junk

Lee
--
Email address is valid, but is unlikely to be read.