[Angel666]

Hi, I've just replaced my pcb board in my glow worm 30cxi combi boiler and
all's good and well on the digital display when I use the hot water it states
around 6.0 but when I put the central heating on the digital display changes
to 49„ƒ something I've never seen before....do I need to reset my thermostat
?? I'm a woman and changed the board myself, so any easy explanation will do
lol....am just wondering if boiler is safe with it saying the temp in „ƒ
rather than 0.6 or 0.8..... thank you

--
for full context, visit https://www.homeownershub.com/uk-diy...d-1222017-.htm

[[email protected]]

On Tuesday, 4 July 2017 17:14:08 UTC+1, Angel666 wrote:
Hi, I've just replaced my pcb board in my glow worm 30cxi combi boiler and
all's good and well on the digital display when I use the hot water it states
around 6.0 but when I put the central heating on the digital display changes
to 49„ƒ something I've never seen before....do I need to reset my thermostat
?? I'm a woman and changed the board myself, so any easy explanation will do
lol....am just wondering if boiler is safe with it saying the temp in „ƒ
rather than 0.6 or 0.8..... thank you

Someone else should be along that knows. Most people won't see your posts because you're using HOH, suggest you use a saner portal to this uk.d-i-y newsgroup.


NT

[Graham.[_11_]]

On Tue, 04 Jul 2017 16:14:05 GMT, Angel666
m wrote:

Hi, I've just replaced my pcb board in my glow worm 30cxi combi boiler and
all's good and well on the digital display when I use the hot water it states
around 6.0 but when I put the central heating on the digital display changes
to 49? something I've never seen before....do I need to reset my thermostat
?? I'm a woman and changed the board myself, so any easy explanation will do
lol....am just wondering if boiler is safe with it saying the temp in ?
rather than 0.6 or 0.8..... thank you


Hi, the installation manual is here
https://www.glow-worm.co.uk/glow-wor...nge-157150.pdf

It says it normally displays the system static pressure in bar and the
water temp in degrees C when the CH is running, so that all seems
reasonable to me. Usually 1.0 bar is recommended so open the filling
loop valve for a short while to increase the pressure.
--

Graham.
%Profound_observation%