Yorkshire fittings
Hi there,
About a year ago I got a plumber to chase some pipes into the bathroom wall behind the bath for a shower -- --| | | | | | Like above, but above a bath - my asci art doesn't extend much further! I'm about to tile over the pipes and notice that that the stubs that come out of the wall to receive the shower fitting are very much boss eyed ... damn! So what to do? Just heat up the elbows with a blow torch and give them a tweak with a mole wrench to bring them into true? Chop the upright pipes and redo it with push fits. Or - moan at the plumber and tell him to get his ass back here and do it right. My incling is the later - but its two years since he did the job ... well I got busy with more pressing things .... Advice appreciated! |
Yorkshire fittings
Depends on the plumber but after two years he may not be too keen if
you have an attitude. It's a five minute job for him so try asking him nicely and see when he's in the area. Adjusting a solder ring is quite simple but practice on a scrap bit of pipe first... won't take many tries to learn. |
Yorkshire fittings
Rob Griffiths wrote:
So what to do? Just heat up the elbows with a blow torch and give them a tweak with a mole wrench to bring them into true? Chop the upright pipes and redo it with push fits. Or - moan at the plumber and tell him to get his ass back here and do it right. My incling is the later - but its two years since he did the job ... well I got busy with more pressing things Note that many showers are supplied with "cranked" fittings that are designed to allow slight mismatches in position to be tuned out during installation. So depending on what you are going to fit you may get away with it anyway. -- Cheers, John. /================================================== ===============\ | Internode Ltd - http://www.internode.co.uk | |-----------------------------------------------------------------| | John Rumm - john(at)internode(dot)co(dot)uk | \================================================= ================/ |
All times are GMT +1. The time now is 10:16 AM. |
Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2014 DIYbanter