Hi All

My sister wants me to fit a MOE window into the slate roof of her two story
garage. It's not going to be a habitable room, it's just safer having an
MOE window instead of standard.

She's bought one from Wickes along with a 'slate flashing kit'.

Window is straightforward enough to fit, but having looked at the flashing
kit I'm a little confused.

The kit consists of a top and a bottom sheet metal component (very thin &
pliable) which fit the top & bottom of the frame, going under a rubber seal.
There are side pieces as well.

The top component is confusing me. The part that will slide under the
slates has a 'lip' bent into the top edge about 6mm high, facing up. This
will mean (a) that it won't slide under the slates easily and (b) it will
lift them by 6mm or so.

Is this meant to cause a 'drip edge' or something? My instinct based on
previous experience is to hammer it flat, but it's obviously there for a
purpose. I'm sure I have identified the top & bottom components correctly,
they are so different it would be impossible to confuse them.

The staff at Wickes are as much use as a chocolate teapot.

Any ideas?


--
Dave
The Medway Handyman
www.medwayhandyman.co.uk
01634 717930
07850 597257