Home |
Search |
Today's Posts |
|
UK diy (uk.d-i-y) For the discussion of all topics related to diy (do-it-yourself) in the UK. All levels of experience and proficency are welcome to join in to ask questions or offer solutions. |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to uk.d-i-y
|
|||
|
|||
Poor shower
I've just moved into a new house, and I have a problem with the
shower. It's a mixer shower in a cubicle gravity fed from the hot water cylinder on the same floor, and the cold tank in the loft just above. It produces not so much a shower as a dribble. My options as I see it a 1. Replace the mixer valve with a pumped shower. This would appear to be the easiest option, as I would have thought it just requires an electrical supply, the water inlets being already in place. 2. Install a pump. This appears as though it will have to go in the airing cupboard, and I'm assuming will therefore need a new hot and cold feed to the shower valve, as well as the wiring. -Two questions he a) can a pump be fitted in the loft above the height of the shower head and the hot water tank? Most typical installations show them being fitted on a level with the hot water cylinder, but if it were fitted in the loft, I could presumably place it in the line of the hot & cold feeds, thereby reducing the amount of plumbing needed; and b) could I take a spur or loop from the immersion heater? 3. Replace the existing vented cylinder with a Megaflo. A bit of a nuclear option, I would have thought, but there was one in the rented flat I've just moved from, and the shower there was almost too powerful. There appears to be good mains pressure here. Is it feasible to simply swap one cylinder for another and bypass the cold water tank, or is there more to it than that? Any thoughts on the pros and cons of these options are welcome. -- Hugo Nebula "If no-one on the internet wants a piece of this, just how far from the pack have you strayed?" |