Home |
Search |
Today's Posts |
|
Electronics Repair (sci.electronics.repair) Discussion of repairing electronic equipment. Topics include requests for assistance, where to obtain servicing information and parts, techniques for diagnosis and repair, and annecdotes about success, failures and problems. |
|
LinkBack | Thread Tools | Display Modes |
#1
Posted to sci.electronics.repair
|
|||
|
|||
12V , 200W , DC motor
Needs new brushes as one had cracked along half the length but not broke
away, so forming a wedge in the slideway. Along with some conglomeration of carbon etc in that part of the slideway and beyond into the gap and presumably into the crack , until it jammed out of contact. Anything to be aware of for the brush composition ? otherwise looks like a mains voltage carbon/graphite brush. No name motor for spares. How to clean off the build up of carbon on the commutator and is there an equivalent , for low V high A motors, of bedding in with bedding stone ? as no aperature available to poke any stone in there when assembled. |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Power module TA-200W for Kenwood KR-9600 | Electronics Repair | |||
200w security light - connect to lighting circuit. | UK diy | |||
Motor wire number to color mapping for Bandsaw motor. | Woodworking | |||
Phonic 740 200w Amp | Electronics Repair | |||
Slow down a drill press: 2nd motor and use the existing motor as a countershaft? | Metalworking |